Поршений цагираг: үзүүрийн завсар, бүрээс, цагираг яагаад хугардаг вэ

Цагираг дөрвөн үүрэг гүйцэтгэдэг: шаталтын хийг битүүмжлэх, поршенийг тулах, тосыг тараах, буцааж хусах. Зөвхөн битүүмжилдэг боловч хусдаггүй цагираг нь хөх утаа, тосны зарцуулалт үүсгэдэг.

End gap decides whether it seals or breaks

The gap is measured with the ring square in the bore, pushed down by the piston crown. Too small and the ends butt together when hot — the ring lifts, scores the liner, or snaps. Too large and you lose compression and blow-by rises.

Check the gap for the top, second and oil ring separately. They are different numbers, and the top ring usually needs the largest.

Coatings and what they buy you

Chrome plating resists scuffing on the top ring. Gas nitriding hardens the whole ring section. Molybdenum or ceramic-particle inlays on the face improve resistance to scuffing and to poor fuel quality.

A coating is a wear margin, not a substitute for correct end gap and a straight bore.

Why a new ring breaks in a rebuilt engine

Usually one of four reasons: the gap was filed to the old bore size, the ring was fitted upside down, the bore had a wear step at the top, or the piston groove was already worn oversize so the ring rocked and cracked.

If a ring breaks within the first few hundred hours, check the groove before blaming the ring.